Wipe-On Poly

Forget precious metals – in our eyes, it’s precious timber.
Protect yours with Feast Watson Wipe-On Poly.
Find In-Store
Select timber
Number of coats

Where to use

All interior woodwork including furniture, doors, windows, architraves, panelling and trim.



Coverage rate

16m² per litre

Number of coats

1 Coat

Dry time

6 hours

Clean up

Mineral Turpentine. Soak application cloths in water prior to disposal.



You may also need

Timber and Deck Oil Water Repellent
Feast Watson Water Repellent Timber & Deck Oil
Floor Clean
Feast Watson Floor Clean
Feast Watson Proofseal™

How to prepare your timber for Feast Watson Wipe-on Poly:

Before getting started:

  1. Fill nail holes, cracks and other defects with a water-based putty after applying the first coat of this product for accurate colour matching.

  2. Remove stains, dirt, wax, grease and oil with mineral turpentine.

  3. Using a suitable polish remover, remove any polish.

Bare Timber

If you are applying Wipe-on Poly to Bare Timber:

  1. Sand to a smooth surface.

  2. Remember to remove all sanding dust before coating.

Note: For naturally oily timbers, seal the timber with Feast Watson Proofseal as per the directions prior to application.

Previously Coated Timber If you are applying Wipe-on Poly to Previously Coated Timber:

  1. Sand back previously varnished surfaces to a dull finish.

  2. Remove all sanding dust before coating.

  3. Thoroughly clean the surface with Floorclean and allow to dry.

  4. Apply one coat to a small test area. Allow to dry for 6 hours.

  5. Press sticky tape firmly to the surface and pull off quickly.

  • If the coating comes off, sand back to bare timber.

  • If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.

Get expert advice and info, straight to your inbox

Sign up to our monthly newsletter to receive helpful project advice, how-to guides, inside information and more.