1. Fill nail holes, cracks and other defects with a water-based putty after applying the first coat of this product for accurate colour matching.

2. Remove stains, dirt, wax, grease and oil with mineral turpentine.

3. Using a suitable polish remover, remove any polish.

If you are applying Wipe-On Poly to Bare Timber:

1. Sand to a smooth surface.

2. Remember to remove all sanding dust before coating.

Note: For naturally oily timbers, seal the timber with Feast Watson Proofseal™ as per the directions prior to application.

If you are applying Wipe-On Poly to Previously Coated Timber:

1. Sand back previously varnished surfaces to a dull finish.

2. Remove all sanding dust before coating.

3. Thoroughly clean the surface with Feast Watson Floor Clean and allow to dry.

4. Apply one coat to a small test area. Allow to dry for 6 hours.

5. Press sticky tape firmly to the surface and pull off quickly.

• If the coating comes off, sand back to bare timber.

• If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.

1. Shake Wipe-On Poly container for one minute prior to use.

2. Apply a generous amount with a clean, lint free cloth in the direction of the grain.

3. Allow to dry for a minimum of 6 hours.

4. If you require additional coats, follow the above instructions. Remember that a light sand with 240 grit sandpaper is recommended between coats.

1. Apply Feast Watson Prooftint™ following label directions prior to the application of Wipe-On Poly.

2. Allow Prooftint™ to dry the recommended period before applying Wipe-On Poly.

Do not pour leftover product down the drain.

Brush leftover product onto newspaper, and allowed to completely dry, before disposing of via general waste collection.

Empty containers should be left open in a well-ventilated area to dry out. When dry, recycle the container through steel can recycle programs such as Paintback.